Visio Util Device Setup

  • Powering The Device

      Step 1:
      Unscrew the 2 screws at the bottom and open the device.

      Step 2:
      Plug in power connector and the green LED will illuminate and turn off

      Step 3:
      Close the device. Make sure to not pinch or overly bend the power cable.
      Check that rubber seal is still in place
      Tighten the screws but be careful not to over tighten.

  • Replace The Battery

      Step 1:
      Unscrew the 2 screws at the bottom and open the device.

      Step 2:
      Unscrew the battery holder clip and replace the old battery
      Screw the battery holder clip back in place.

      Step 3:
      Close the device. Make sure to not pinch or overly bend the power cable.
      Check that rubber seal is still in place
      Tighten the screws but be careful not to over tighten.

  • Install The Device - Water Meters

    Please refer to the below image for connecting to Pulse (Usually Reed Switch) interface:

  • Install The Device - Electricity Meters

    Please refer to the below image for connecting to Pulse interface:


Device Specifications
(Support Center) Log Support Tickets